Working Safely; Maintenance/Cleaning; Storage; Spare Parts - FLORABEST FHT 900 B3 Betriebsanleitung

GB

Working Safely

Observe the specified working angle (see
illustration above), in order to guarantee
safe working.
Do not use the high pruning saw when
standing on a ladder or in an unsafe positi-
on.
Do not be tempted to make unconsidered
cuts. Doing so may endanger both yourself
and others.
Children must be supervised to ensure that
they do not play with the equipment.

Maintenance/Cleaning

Repair and servicing work not de-
scribed in this manual should always
be carried by our Service Centre.
Use only original parts.
Pull out the power plug before carry-
ing out any work on the equipment.
Wear gloves while handling the
blades.
Carry out the following maintenance and
cleaning work regularly. This will guarantee
a long and reliable service life.
• Before each use, check the hedge trim-
mer for obvious defects such as loose,
worn or damaged parts. Check the
secure seating of the bolts in the cutter
bar.
42
• Do not use the unit if the blades are
blunt or worn. This will overstress the
motor and gearbox of the machine.
• Check coverings and safety devices for
damage and correct seating. Replace
these where necessary.
• Keep the ventilation slots and motor
housing of the device clean. Use a
damp cloth or a brush to do this. Do not
wash down the equipment with water,
or submerge it in water.
• Do not use any cleaning agents or
solvents. These could cause irreparable
damage to the equipment. Chemical
substances can attack the plastic parts
of the equipment.
• Clean the cutter bar carefully after each
use. Wipe it off with an oily cloth or
spray it with a metal protective spray.
• Keep the hedge trim-
mer dry and covered
with the blade protec-
tion supplied and out
of reach of children.
• The gears is maintenance free

Storage

• Keep the trimmer in the blade guard
supplied, in a dry place and out of
reach of children.

Spare Parts

Replacement parts may be ordered directly
from our Service Centre.
When ordering, always specify the ma-
chine type and the part number in the ex-
ploded drawing.