Setting Up; Selecting The Speed; Checking The V-Belt - Parkside PTBM 500 A1 Betriebsanleitung

- All hoods and protective devices
must be assembled properly be-
fore commissioning.
- Disconnect the mains plug be-
fore changing the setting on the
device.

Setting up

Place the bench drill on a solid surface.
Ideally, bolt the drill to the surface. Use the
two holes in the baseplate (17) for this.

Selecting the speed

1. Release the locking bolt (11) on the
gear cover (8).
2. Open the gear cover (8).
3. Release the retaining bolt (13) on the
motor unit (14).
4. Slide the motor unit (14) forward a little
to release the load on the V-belt (26).
5. Place the V-belt (26) on the desired as-
sembly to reach the specified speed:
Ø [mm]: Ø [mm]:
< 3 < 4
3 - 4 5 - 6
5 7 - 8
6 - 8 9 - 10
> 8 > 10
6. Slide the motor unit (14) back to tensi-
on the V-belt (26) again.
7. The V-belt (26) is correctly tensioned
8. Tighten the retaining bolt (13) on the
9. Close the gear cover (8). Fasten the
Recommended speeds for
different drill sizes and materials:
[1/min]:

Checking the V-belt

1. Release the locking bolt (11) on the
2. Open the gear cover (8).
3. Check the tension of the V-belt (26).
4. The V-belt (26) is correctly tensioned
5. Check the V-belt (26) for tears, cuts or
when it gives way slightly when
pressed.
motor unit (14) again.
locking bolt (11) on the gear cover .
The gear cover (8) is equipped with
a safety switch (27). If the gear
cover (8) is not closed correctly, the
device cannot be switched on.
Ø [mm]: Ø [mm]:
< 3 < 4
3 - 4 5 - 6
5 7 - 8
6 - 8 9 - 10
> 8 > 10
gear cover (8).
when it gives way slightly when
pressed.
other damage.
GB IE CY
[1/min]:
11