Assembly; Operation; Setting Up; Selecting The Speed - Parkside PTBM 500 C3 Betriebsanleitung

A
• Edit not work pieces that you can not sure
retain. Especially round or uneven
workpieces.
K

Assembly

The bench drill is supplied disassembled.
U
Clean the column tube (14), baseplate
(17), drilling bench (20), vice (23) and
the drill chuck (4) beforehand, with a dry
cloth.
1. Place the column tube (14) on the ba-
seplate (17). Bolt the column tube (14)
to the baseplate (17) with the three as-
sembly srews (16) supplied. Tighten the
assembly srews (16) moderately tight
so that the threads in the baseplate (17)
do not strip.
2. Place the drilling bench (20) on the co-
lumn tube (14). Push the drilling bench
(20) into a lower
locking handle (15) to fix the drilling
bench (20) in a lower position.
B C
3. Place the vice (23) on the drilling
bench (20) and screw it with the
enclosed mounting bolts (22)
tightly to the drilling bench (20).
L M
C D
4. Place the motor unit (13) on the
column tube (14) and secure the
V W
A B
motor unit (13) with the clam-
M N
ping screw (27) to the side with
the allen key (25) supplied.
K L
D E
5. Bolt the three drill lifting arms
W X
into the spindle guide (9). Tigh-
ten the three hole lifting arms
U V
N with a spanner (AF 6 mm). O
6. Release the clamping screw from
the depth stop (8).
X Y
B C
L M
V W
position. Use the
D E
N O
E F
X Y
C D
O P
M N
F G
Y Z
W X
P Q
Z
D E
7. Put the safety device (6) on the
8. Secure the safety device (6) with
N O
9. Fold the safety device (6) up-
X Y

Operation

Caution! Risk of injury!
- Ensure that you have sufficient
- All hoods and protective devices
- Disconnect the mains plug be-
F G

Setting up

Place the bench drill on a solid surface.
P Q
Ideally, bolt the drill to the surface. Use the
G H
four holes in the baseplate (17) for this.
Z
E F

Selecting the speed

Q R
1. Release the locking bolt (11) on the
O P
gear cover (3).
H I
2. Open the gear cover (3).
3. Release the two retaining bolts (12) on
the motor unit (13).
Y Z
R 4. Slide the motor unit (13) forward a little S
to release the load on the V-belts (29).
5. Place the V-belts (29) on the desired
assembly to reach the specified speed:
F G
upper part of the drill spindle (7).
P Q
the clamping screw (28).
Z
wards. Insert the chuck (4) on
the taper of the drill spindle (7).
Push the drill chuck onto the drill
chuck tip with a few light taps.
Use a plastic hammer for this
purpose.
space in which to work and that
you do not endanger other people.
must be assembled properly be-
fore commissioning.
fore changing the setting on the
device.
H I
R S
I J
G H
S T
Q R
J
T
GB
H I
R S
J
T
I J
S T
1 1
J
T