Master-Slave Mode; D) Sound-To-Light Mode; E) Colour Change Operation - Renkforce POWERPAR 6x8 W Bedienungsanleitung

c) Master-slave mode
• Push the button MENU until "SLAU" is displayed and push the button ENTER.
• Use the buttons UP or DOWN to select the desired operating mode:
NO Master device
YES Slave device
• Press the ENTER button to confirm your selection.
If the device is to be operated as a single device (standalone), it must be defined as a master
device.
Only one device in a master-slave-chain must be defined as master device. All other devices
must be defined as slave devices.

d) Sound-to-light mode

• Push the button MENU until "SOUn" is displayed and push the button ENTER.
• Select the desired operating mode with the UP and DOWN buttons:
Sd-1 Sound-to-light effect 1
Sd-2 Sound-to-light effect 2
Sd-3 Sound-to-light effect 3
• Press the ENTER button to confirm your selection.
• Set the microphone sensitivity for sound-to-light operation with the buttons UP and DOWN:
SP-1 (sensitivity low) > SP-8 (sensitivity high)
• Press the ENTER button to confirm your selection.
• The effect light is controlled via the installed microphone in time with the music in this mode.
• Set the microphone sensitivity so that the light effect changes in time with the music.

e) Colour change operation

• Push the button MENU until "JUNP" is displayed and push the button ENTER.
• Select the desired effect speed with the UP and DOWN buttons:
JU01 (slow) > JU20 (fast)
• Press the ENTER button to confirm your selection.
• Set the desired strobe speed with the buttons UP or DOWN:
FL-0 (slow) > FL-4 (fast)
• Press the ENTER button to confirm your selection.
36