Master-Slave Mode; D) Sound-To-Light Mode - Renkforce MINIPAR 18 x 1 W Bedienungsanleitung

c) Master-Slave Mode
• Push the button MENU (3) until "SLAU" is displayed and push the button ENTER (6).
• Use the buttons UP (4) or DOWN (5) to select the desired operating mode:
NO Master device
YES Slave device
• Press the ENTER button (6) to confirm your selection.
If the device is to be operated as a single device (standalone), it must be defined as a
master device.
Only one device in a master-slave-chain must be defined as master device. All other
devices must be defined as slave devices.

d) Sound-to-light mode

• Push the button MENU (3) until "SOUn" is displayed and push the button ENTER (6).
• Select the desired operating mode with the UP (4) and DOWN (5) buttons:
Sd-1 Sound-to-light effect 1
Sd-2 Sound-to-light effect 2
Sd-3 Sound-to-light effect 3
• Press the ENTER button (6) to confirm your selection.
• Set the microphone sensitivity for sound-to-light operation with the buttons UP (4) and DOWN
(5):
• SP-1 (sensitivity low) > SP-8 (sensitivity high)
• Press the ENTER button (6) to confirm your selection.
The effect light is controlled via the installed microphone in time with the music in this
mode. Set the microphone sensitivity so that the light effect changes in time with the
music.
42