Automatic Operation; Master-Slave Mode; E) Sound-To-Light Mode - Renkforce GM106NS LED Bedienungsanleitung

c) Automatic Operation
• Push the button MENU (2) until "Shnd" is displayed and push the button ENTER (5).
• Select the desired automatic effect "Sh 0" to "Sh 4" with the DOWN (3) and UP (4) buttons:
Sh 0 Automatic effect 1
Sh 1 Automatic effect 2
Sh 2 Automatic effect 3
Sh 3 Automatic effect 4
Sh 4 Automatic effect 5
• Push the ENTER button (5) to confirm your selection.
d) Master-Slave Mode
• Push the button MENU (2) until "SLNd" is displayed and push the button ENTER (5).
• Select the desired operating mode with the DOWN (3) and UP (4) buttons:
NASt Master mode
SL1 Slave mode
• Push the ENTER button (5) to confirm your selection.
If the device is to be operated as a single device (standalone), it must be defined as a master
device.
Only one device in a master-slave-chain must be defined as master device. All other devices
must be defined as slave devices.

e) Sound-to-Light Mode

• Push the button MENU (2) until "SoUn" is displayed and push the button ENTER (5).
• Select the desired operating mode with the DOWN (3) and UP (4) buttons:
on Sound-to-light mode activated
oFF Sound-to-light mode deactivated
• Push the ENTER button (8) to confirm your selection.
• The effect light is controlled via the installed microphone (6) in time with the music in this mode.
• The sensitivity of the sound-to-light control is set in the menu in item "SenS".
• Push the button MENU (2) until "SenS" is displayed and push the button ENTER (5).
• Select the desired microphone sensitivity (0-100) with the buttons DOWN (3) or UP (4) and push the but-
ton ENTER (5) again to confirm.
Sound-to-light operation takes precedence over automatic mode. Always switch off sound-to-
light control before choosing the automatic mode.
40