Loading Factory Settings; J) Inversion Of The Display Alignment; Display Of The Firmware Version; Master-Slave Mode - Renkforce GM107 Bedienungsanleitung

• Press the ENTER button (4) to confirm your input.
• The internal controller restarts the moving head after the option YES is selected.
i) Loading Factory Settings
After comprehensive changes to the configuration, it may be necessary to reset the device to factory
settings. For this, perform the following steps.
• Select LoAd in the menu.
• Push the button ENTER (4) and use the buttons UP (2) and DOWN (3) to set NO or YES.
NO The factory settings are not loaded.
YES The factory settings are loaded.
• Press the ENTER button (4) to confirm your input.
• The internal controller restores the factory settings after the option YES is selected.

j) Inversion of the Display Alignment

• Select dISP in the menu.
• Push the button ENTER (4) and use the buttons UP (2) and DOWN (3) to set NO or YES.
NO The display alignment is not inverted.
YES The display alignment is inverted.
• Press the ENTER button (4) to confirm your input.
k) Display of the Firmware Version
• Select vEr in the menu.
• Push the button ENTER (4), to display the current firmware version.
l) Master-Slave Mode
• Select the automatic or sound-to-light operation in the menu of the master unit.
• Set the DMX starting address at all slave devices to A001.
Only one device in a master-slave-chain must be defined as master device. All other devices
must be defined as slave devices (DMX starting address A001).
33