Herunterladen Inhalt Inhalt Diese Seite drucken

Battery Of The Remote Control - Renkforce POWERPAR 6x8 W Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

• If you have not done so yet, attach the included mounting bracket to the casing with the lateral thumb-
screws.
• If you want to set up the effect spotlight, turn the two parts of the mounting bracket so that they form a
base and then tighten the two thumbscrews and the two small screws at the bracket.
• If you want to suspend the effect spotlight, turn the mounting bracket up.
• Install the effect spotlight on the ceiling, the wall or a suitable crossbeam with the mounting bracket. The
assembly must never swing freely.
• Secure the device with assembly equipment that is compatible with the attachment surface and suitable
for carrying the weight of the effect light.
• Additionally secure the installation with a suitable safety restraint cable or a safety net. The safety reten-
tion rope or the net must be designed to support the effect light in the event of failure of the main support
system independently of the main attachment.
• Set the desired inclination angle and tighten the thumb screws well.

8. Battery of the remote control

Keep batteries out of reach of children.
Observe correct polarity when inserting the battery.
Remove the battery when the device is not in use for extended periods of time.
Leaking or damaged batteries/rechargeable batteries can cause chemical burns to skin when
touched without the use of adequate protective gloves.
Do not short-circuit the battery and do not throw it into fire. It also must not be recharged. Dan-
ger of explosion.
At initial commissioning, the battery of the remote control is protected from discharge by an
isolation film. Remove the film before use by pulling it out of the remote control's battery compart-
ment.
Battery change
• Pull the battery holder at the rear of the remote control out.
• Remove the discharged battery and insert a new 3 V lithium button cell CR2025. The correct polarity is
indicated on the rear of the remote control.
• Insert the batteries in the remote control again.
• If the remote control no longer functions properly or the range reduces, the battery is discharged and
must be replaced with a new one of the same type.
29

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis