D) Sound-To-Light Mode; Setting Of The Microphone Sensitivity In Sound-To-Light Operation; F) Blackout Mode; G) Display Deactivation - Renkforce SC-12 Bedienungsanleitung

d) Sound-to-light mode

• Use the MENU (4) button to select SoUn in the menu and push the ENTER (7) button.
• Select the desired operating mode with the UP (6) and DOWN (5) buttons.
on Sound-to-light mode activated
oFF Sound-to-light mode deactivated
• Press the ENTER button (7) to confirm your selection.
The device is controlled via the installed microphone (2) in time with the music in this mode.
e) Setting of the microphone sensitivity in sound-to-light operation
• Use the MENU (4) button to select SenS in the menu and push the ENTER (7) button.
• Select the desired microphone sensitivity with the UP (6) and DOWN (5) buttons.
0 Microphone sensitivity low
100 Microphone sensitivity high
• Press the ENTER button (7) to confirm your selection.
Set the microphone sensitivity so that the light effect changes in time with the music.

f) Blackout Mode

• Use the MENU (4) button to select bLAC in the menu and push the ENTER (7) button.
• Select the desired function with the UP (6) and DOWN (5) buttons.
YeS Light is switched off (blackout function is activated)
no Light is switched on (blackout function is deactivated)
• Press the ENTER button (7) to confirm your selection.

g) Display deactivation

• Use the MENU (4) button to select Led in the menu and push the ENTER (7) button.
• Select the desired function with the UP (6) and DOWN (5) buttons.
on Display (3) permanently on
oFF The display (3) switches off after approx. 70 s after the last button is pushed.
When any button is pushed again, the display (3) will be activated again.
• Press the ENTER button (7) to confirm your selection.
36