Trouble-Shooting And Service; Environment And Recycling - clage S 30 Montageanleitung

9. Trouble-shooting and service

If your device does not function as intended, it is usually due to a small detail. Please check whether or not the fault
can be self-repaired according to the following indicators. You will thereby avoid the costs of an unnecessary repair
service.
Repairs must only be carried
out by authorised profession-
als.
If a fault in your appliance
cannot be rectified with the
aid of this table, please contact
the service organisation of
your importer or the Central
Customer Service Department.
Please have the details of the
typeplate at hand.
CLAGE GmbH
After-Sales Service
Pirolweg 1 – 5
21337 Lüneburg
Germany
Phone: +49 4131 8901-40
Fax: +49 4131 8901-41
Email: service@clage.de
If the connection cable is damaged, it must be replaced with an original spare cable from the manufacturer by an
authorised technician in order to avoid any hazards.
If you cannot rectify the fault with the aid of the troubleshooting table, please contact the custo mer service.

10. Environment and recycling

Your product was manufactured from high-quality, reusable materials and components. Please respect in case of dis-
carding that electrical devices should be disposed of separately from household waste at the end of their service life.
Therefore, please take this device to a municipal collection point that accepts electronic scrap. Disposing it correctly
will support environmental protection and will prevent any potential negative effects on human beings and the envi-
ronment that could arise from inappropriate handling of these devices at the end of their service life. Please contact
your local authority for further details of your nearest designated collection point or recycling site.
Business customers: If you wish to discard equipment, please contact your dealer or supplier for further information.
Problem
Water does not flow
Water does not heat
up
Steam emerges
Little water flows
Short-circuit
(fuse tripped)
No expansion water
Water not hot enough
19
Solve
check and open main water tap, service valve, shut
off valve if necessary
check fittings and hose connections
check fuse and electrical connection
call customer service department to check thermal
cut-out, thermostat or heating element if necessary
check temperature setting on appliance
disconnect the power supply, let the appliance
checked by a customer service engineer
check water pressure(< 1,5 bar)
clean jet regulator at the outlet of the tap
let the appliance and its installation checked by a
customer service engineer
pull out the main plug and contact the customer
service
check temperature setting on appliance
too much hot water may have been withdrawn
within a short space of time, wait for the water to
heat up again
CLAGE