Sentiotec Pro B3 Montage- Und Gebrauchsanweisung Seite 49

Instructions for installation and use p. 11/38
Single-sensor mode (F1)
Single-sensor mode must be activated when starting up the sauna for the i rst
time (see 8.4. Activating/deactivating the single-sensor mode on page 27).
In single-sensor mode, the sauna control unit is operated with the heater sensor
with excess temperature fuse (F1) only. This is included in the scope of delivery.
In single-sensor mode, the sauna control unit only displays the set temperature
as standard. The actual temperature is not displayed. Should the sauna control
unit display the temperature above the heater (F1) as an actual temperature
in single-sensor mode, it must be activated when starting up for the i rst time (see
8.5. Displaying the heater temperature in single-sensor mode on page 27)
The maximum humidity level which can be set is based on the temperature
above the heater, and the humidity is timed. Only the set value for the humidity
level (in % of relative humidity) is displayed by the sauna control unit. The actual
humidity level in the sauna room when humidity is timed depends on the size
of the room and the evaporator capacity, and may deviate from the set value.
Two-sensor mode with bench sensor (F2)
In two-sensor mode with bench sensor, a second temperature sensor (bench
EN
sensor) is installed above the rear sauna bench. The sauna control unit displays
the temperature measured by the bench sensor as the actual temperature.
In two-sensor mode with bench sensor, the humidity is timed. Only the set
value for the humidity level (in % of relative humidity) is displayed by the sauna
control unit. The actual humidity level in the sauna room when humidity is timed
depends on the size of the room and the evaporator capacity, and may deviate
from the set value.
WORLD OF WELLNESS