Starting Combi Mode; Changing The Preset Temperature - Sentiotec Pro B3 Montage- Und Gebrauchsanweisung

Instructions for use for the user
9.5.

Starting combi mode

1. Use the temperature selector
► The temperature selector
in the temperature display
2. Press the temperature selector
► The sauna heater is switched on and begins to heat up.
► Then the current temperature in the sauna room is displayed in the
temperature display
is displayed.
3. Use the humidity selector
► The humidity selector
in the humidity display
4. Press the humidity selector
► The evaporator switches on.
► Then the current temperature in the sauna room is displayed in the hu-
midity display
preset humidity is displayed.
9.6.

Changing the preset temperature

You can change the preset temperature during operation any time.
● Turn the temperature selector
Turn the temperature selector
► The temperature selector
in the temperature display
► Then the current temperature in the sauna room is displayed again in the
temperature display
is displayed.
WORLD OF WELLNESS
3
to set the preferred temperature.
lashes and the preset temperature is shown
3
4
.
3
4
. In single-sensor mode, the preset temperature
2
to set the preferred humidity.
lashes and the preset temperature is shown
2
1
.
2
.
1
. If a humidity temperature sensor is not installed, the
3
to the right to increase the temperature.
3
to the left to decrease the temperature.
lashes and the preset temperature is shown
3
4
.
4
. In single-sensor mode, the preset temperature
.
p. 30/38