Amplifying The Analogue Input Signal - G&D Audio-Transceiver-Fiber Installationsanleitung

Amplifying the analogue input signal

A rotary switch lets you amplify the analogue audio signal coming in at the
interface. In the defaults, the rotary switch is set to
Micro In
Link Status
Transmission
NOTE: The drawing shows the digital variant of the
The following table lists the different switch settings and the respective amplification of
the input signal:
Switch setting Amplification of the analogue input signal (Line In/Micro In)
0 0 dB (no amplification)
1 3 dB
2 6 dB
3 9 dB
4 12 dB
5 15 dB
6 18 dB
7 21 dB
8 24 dB (maximum amplification)
9 24 dB (maximum amplification)
NOTE: A high level of the input signal and the simultaneous amplification may
lead to an overdriving of the audio signal. Decrease the level of amplification if
the audio signal is distorted.
Digital Audio
Audio
Service
Power
Out
Audio-Transceiver-Fiber
Amplifying the analogue input signal
:
0
2 3
1 4
5
0
9 6
8 7
Line In/
Micro In
In
Audio-Transceiver-Fiber
Audio-Transceiver-Fiber · 7
Line In/
Line Out/
Speaker
series.