To Tune In To A Particular Ensemble Without Searching - JVC KD-SH9101 Bedienungsanleitung

3
Start searching for an ensemble.
Press ¢
ensembles of higher
frequency.
Press
ensembles of lower
frequency.
When an ensemble is received, searching
stops.
To stop searching before an ensemble is
received, press the same button you have
pressed for searching.
4
Select a service (either primary or
secondary) you want to listen to.
Press 5 (up) to select the
next service. (If a primary
service has some secondary
services, they are selected
before the next primary
service is selected.)
Press ∞ (down) to select the
previous service (either
primary or secondary).
To tune in to a particular ensemble
without searching
1
Press SRC repeatedly to select DAB tuner as
the source.
2
Press and hold SRC for more than 1 second.
3
Press SRC repeatedly to select the DAB
band (DAB1, DAB2, or DAB3).
Press and hold ¢
4
than one second.
Press ¢
5
or
ensemble you want is reached.
• If you hold down the button, the frequency
keeps changing until you release the button.
Press 5 (up) or ∞ (down) to select a service
6
(either primary or secondary) you want to
listen to.
to search for
4 to search for
4 for more
or
4 repeatedly until the
When noises generated while running
interfere with your listening
While driving, surrounding sounds will interfere
with your listening. Especially the low level
sounds will be hard to listen.
If this happens, you can reinforce the low level
sounds to improve your listening.
For this purpose, some service provides
Dynamic Range Control signals together with
their regular program signals.
1
Press MODE (M) while listening to
a DAB service.
"Mode" appears on the display, and
the number buttons start flashing.
2
Press number button 1 repeatedly to activate
the DRC function while "Mode" is still on the
display.
1 2 3
Each time you press the button, the DRC
function will be set as follows:
DRC 1 DRC 2
DRC Off
As the number increases, the DRC effect level
also increases.
After about
5 seconds
The display returns to the source indication
screen.
• The DRC indicator will be highlighted
( ) only when the unit received DRC
signals from the tuned service.
To cancel the DRC effect, select "DRC Off."
MODE
M
4 5 6
DRC 3
DRC indicator appears
63