JVC KD-SH9101 Bedienungsanleitung Seite 34

2
Press number button 6 to enter the
further precise setting screen.
6
3
Select your listening seats position.
1 2
• Press number button 1 to select "LEFT
(front left)" seat.
• Press number button 2 to select "RIGHT
(front right)" seat.
• Press number button 3 to select "FRONT"
seats.
• Press number button 4 to select "ALL"
seats.
Note:
If fader or balance has been set close to its
extreme, appropriate effect may not be obtained.
4
Press number button 5 to set the
number of the built-in speakers.
• Select "4ch" for the four
speaker system, and "2ch" for
5
the two speaker system.
Note:
When "4ch" is selected, rear speakers are used
only to reproduce reflections and reverberations
in order to creates a being-there feeling in your
car compartment.
34
3 4 5
5
If you select "4ch," rotate the control
dial to select your car size.
ATT
• Compact: Select when the distance from
• Middle: Select when the distance from
6
• Large:
Note:
If you have selected "2ch" in the previous step,
you cannot select the car size.
To go back to the DSP mode selection screen,
press number button 6.
To exit from the DSP mode selection screen,
press SEL (select) repeatedly or wait for about 15
seconds.
As you rotate it, the car size
changes as follows:
Compact Middle
the rear speakers to the listening
seat position is shorten than that
from the front speakers.
the rear speakers to the listening
seat position is almost equal to
that from the front speakers.
Select when the distance from
the rear speakers to the listening
seat position is longer than that
from the front speakers.
Large