To Change The Display Information While Tuning Into An Ensemble; To Tune In A Particular Ensemble Without Searching; Selecting Available Tuning Range - JVC KD-SX1500R Bedienungsanleitung

To change the display information while tuning into an
ensemble
Normally service name and ensemble name is shown on the display.
If you want to check other information, press DISP.
Each time you press the button, the following information appears for a while on the display.
Service name / Ensemble name
Service name / PTY (Prpgram Type) *
Service name / "Primary" or "Secondary"/
Band / Preset number
Dynamic Label Segment **
Ensemble name / Frequency / Channel no.
Service name / Clock time
Service name / Level meter ***

To tune in a particular ensemble without searching:

1 Press DAB repeatedly to select the DAB band (DAB 1, DAB 2, or DAB 3).
2 Press and hold
Now you can manually change the frequency while "Manual" is flashing.
¢ or 4
3 Press
• If you hold down the button, the frequency keeps changing until you release the button.
4 Press 5 or ∞ to select the service you want.

Selecting available tuning range

DAB services are broadcast on the following frequency bands — VHF (BAND III): 174 to 240
MHz, L-BAND: 1452 to 1492 MHz.
In some areas, only one of them are used for broadcasting. So, if you know which band is
used in your area, you can select one of or both of these frequency bands as the tuning range
of DAB band of this unit. If you set the tuning range correctly, tuning or searching speed will
become faster. When shipped from the factory, the tuning range for each DAB band has been
set to "VHF & L-BAND."
• REMEMBER if you do the following operation, the microcomputer built-in the DAB tuner will
be reset to the initial settings.
1 Press and hold DAB for more than 2 seconds.
2 Rotate the control dial to select a proper frequency band for the DAB band in your area.
3 Press and hold DAB for more than 2 seconds again to finish the setting.
38
¢ or 4
until "Manual" starts flashing on the display.
repeatedly until the ensemble you want is reached.
–
VHF & L Band
*
Each service can have several PTY codes and
can use two types of PTY code — "Static PTY"
and "Dynamic PTY." Static PTY does not
change for the service and shows what program
this service is, for example, "Pop Music" or
"Rock Music." On the other hand, Dynamic
PTY changes as the service goes on to show
its actual and current contents. When Dynamic
PTY is shown on the display, it flashes.
**
Dynamic Label Segment (DLS): Text
information sent with the tuned service. Not
displayed when "DAB Text" is set to "Off."
(See page 46.)
*** Not displayed when "Level Meter" is set to
"Level Meter Off." (See page 28.)
–
VHF
L Band