To Change The Display Information While Tuning Into An Ensemble; To Tune In A Particular Ensemble Without Searching - JVC KD-LX50R Bedienungsanleitung

3
To search ensembles
of higher frequencies.
To search ensembles
of lower frequencies.
4
2
1
To stop searching before an ensemble is received, press the same button you have pressed
for searching.
To change the display information while tuning into an
ensemble
Normally service name is shown on the upper part of the display.
If you want to check the ensemble name or its frequency, press DISP.
Each time you press the button, the following information appears for a while on the upper
part of the display.
Service name

To tune in a particular ensemble without searching:

1 Press SOURCE (ATT) to select DAB tuner as the source.
2 Press MODE BAND repeatedly to select the DAB band (DAB1, DAB2, or DAB3).
3 Press and hold
¢ or 4
4 Press
• If you hold down the button, the frequency keeps changing until you release the button.
Select an service you want to listen to.
1 Press MODE BAND.
"MODE" appears on the lower part of the display.
2 Press
while "MODE" is still on the display.
Ensemble name
¢ or 4
for more than 1 second.
repeatedly until the ensemble you want is reached.
Start searching an ensemble.
When an ensemble is received, searching stops.
¢ or 4
to select a service you want,
Channel number Frequency
71