Troubleshooting - JVC KD-SH9101 Bedienungsanleitung

TROUBLESHOOTING

What appears to be trouble is not always serious. Check the following points before calling a service
center.
Symptoms
• Sound is sometimes
interrupted.
• Sound cannot be heard
from the speakers.
• CD-R/CD-RW cannot be
played back.
• Tracks on the CD-R/CD-RW
cannot be skipped.
• Disc cannot be ejected.
• Disc cannot be recognized
("No Disc," "Loading Error,"
or "Eject Error" flashes).
• This unit does not work at
all.
• When "Reset P00" to "Reset
P44" appears on the
display.
•
OVER) indicator appears
on the display.
• "Panel Connect Error"
appears on the display.
• SSM automatic preset
does not work.
• Static noise while listening
to the radio.
72
You are driving on rough
roads.
Disc is scratched.
Connections are incorrect.
The "PowerAmp" setting is set
to "Off."
Connections are incorrect.
Disc is inserted upside down.
CD-R/CD-RW is not finalized.
Disc is locked.
The CD player may function
incorrectly.
The built-in microcomputer
may have functioned
incorrectly due to noise, etc.
There is something is blocking
the control panel movement.
(INPUT Input level through the
external component (LINE
IN) is too high.
The control panel is not
attached correctly and firmly.
Signals are too weak.
The antenna is not connected
firmly.
Causes
Stop playback while driving on
rough roads.
Change the disc.
Check the cords and
connections.
Set it to "On" (see page 49).
Check the cords and
connections.
Insert the disc correctly.
• Insert a finalized
• Finalize the CD-R/CD-RW
Unlock the disc (see page 30.)
While holding
for more than 2 seconds to eject
the disc.
Press the reset button on the
control panel using a ball-point
pen (see page 2).
Press the reset button on the
control panel using a ball-point
pen (see page 2). If the reset
button does not work. Check the
installation. (Ex. you have used a
screws which are longer than
specified.)
Adjust the output level on the
external
Remove the control panel, wipe
the connectors, then attach it
again (see page 53).
Store stations manually.
Connect the antenna firmly.
Remedies
CD-R/CD-RW.
with the component which
you used for recording.
, press 0
component.