Changing The Display Pattern - JVC KD-SH9101 Bedienungsanleitung

Selecting a preset station using the
preset station list
If you forget what stations are stored in what
preset numbers, you can check the preset station
list, then select your desired station on the list.
1
Select the band (FM1 – 3, AM).
1 Press SRC (source)
SRC
2 Press and hold SRC for more
3 Within about 5 seconds, press
AM
FM1
FM3 FM2
2
Press and hold 5 (up) or ∞ (down) until
the preset station list for the current
band (FM1, FM2, FM3, or AM) appears
on the display.
The currently received station will
be highlighted on the display.
Notes:
• If one of FM band preset station lists (FM1,
FM2, or FM3) is shown on the display, you
can show the other lists by pressing 5 (up) or
∞ (down).
• If a preset station is an FM RDS station with
PS signal, PS name will be shown instead of
the station frequency.
3
Select the number (1 – 6) for the preset
station you want.
1 2
14
repeatedly to select the tuner.
than 1 second.
SRC again.
Each time you press the
button, the band changes.
3 4 5

Changing the display pattern

By pressing DISP (D), you can change the
information shown on the display.
Each time you press the button, the
D
display patterns change as follows:
DISP
• Initial display pattern:
• Programme station (PS) name is
emphasized:
* 1
"No Name" always appears for AM or FM non-RDS
stations (see the following pages).
2
*
Appears only when selecting a preset station.
3
*
PTY code appears only when receiving an RDS
station.
6
2
*
1
*
3
*