Makita EN5950SH Originalbetriebsanleitung Seite 15

STOPPING
1) Release the throttle lever (β) fully, and when the engine speed has lowered, set
the Iάτ switch to STτP the engine will now stopέ
β) Be aware that the cutting head may not stop immediately and allow it to slow
down fully.
ADJUSTMENT OF LOW-SPEED ROTATION (IDLING)
When it is necessary to adjust the lowάspeed rotation (idling), perform it by the
carburetor adjusting screwέ
CHECKUP OF LOW-SPEED ROTATION
ά Set the lowάspeed rotation to γ,ίίί rpm (ήmin)έ
If it is necessary to change the rotation speed, regulate the adjusting screw
(illustrated on the right), with Phillips screwdriverέ
ά Turn the adjusting screw to the right, and the engine speed will increaseέ Turn the
adjusting screw to the left, and the engine speed will dropέ
ά The carburetor is generally adjusted before shipmentέ If it is necessary to readjust
it, please contact Authorized Service Agentέ
(1)
Carburetor
Adjusting
screw
15
STτP
(β)