Makita EN5950SH Originalbetriebsanleitung Seite 14

4) Recoil starter
Pull the start knob gently until it is hard to pull (compression point)έ Then, return
the start knob, and pull it stronglyέ σever pull the rope to the full extensionέ τnce
the start knob is pulled, never release your hand immediatelyέ Hold the start
knob until it returns to its original pointέ
η) Warmάup operation
Continue warmάup operation for β to γ minutesέ
στTEμ In case of excessive fuel intake, remove the spark plug and pull the starter
handle slowly to remove excess fuelέ Also, dry the electrode section of the
spark plugέ
Caution during operation:
If the throttle lever is opened fully in a noάload operation, the engine speed is
increased to 1ί,ίίί min (rpm) or moreέ σever operate the engine at a higher
ά1
speed than required and at an approximate speed of θ,ίίί ά λ,ίίί min
B: Startup after warm-up operation
1) Repeat pushing the primer pump gentlyέ
β) Keep the throttle lever at the idling positionέ
γ) Pull the recoil starter stronglyέ
4) If it is dificult to start the engine, open the throttle by about 1ήγέ
Pay attention to the cutting blades which may moveέ
At times, such as winter, when starting the engine is dificult, operate choke
lever with the following procedure when starting engine.
• After implementing startup steps 1) to γ), set choke lever to the CδτSE positionέ
• Implement startup step 4) and start engineέ
• τnce engine starts, set choke lever to the τPEσ positionέ
• Implement startup step η) and complete warm upέ
CAUTIτσμ If a bang (explosive sound) is heard and the engine stops, or the
justάstarted engine stalls before the choke lever is operated, return the
choke lever to the τPEσ position, and pull the starter knob a few times
again to start the engineέ
CAUTIτσμ If the choke lever is left in the CδτSE position, and the starter knob
merely pulled repeatedly, to much fuel will be sucked in, and the engine
will become dificult to startέ
(rpm)έ
ά1
14