Precautions Before Starting The Engine; Points In Operation And How To Stop - Makita EN5950SH Originalbetriebsanleitung

PRECAUTIONS BEFORE STARTING THE ENGINE

ά At all times allow a 1ηάmeter diameter safety zone around the working areaέ
εake sure that all persons (in particular children) andήor animals remain outside
this zone.
ά Before using the pole hedge trimmer, make sure that the machine is in safe
operational conditionέ εake sure that the cutting blades are not damaged, and
check the throttle lever for easy actionέ εake sure that the cutting blades are
not in motion when the engine is idlingέ If the machine is not operating normally,
contact your dealer to have the machine adjustedέ εake sure that the handles
are clean and dry, and test whether the Iάτ switch is functioning properlyέ Start
the engine only in accordance with the instructions given in this manualέ Do not
use any other methods to start the pole hedge trimmerέ
ά Start the engine of the pole hedge trimmer only after having read and fully
understood the instructionsέ σever attempt to start a pole hedge trimmer that has
not been fully assembled. Serious injury may result otherwise.
ά Before starting the engine, always make sure that the cutting blades are not
obstructed by stones, branches or any other solid objectsέ
ά Check the working area for wires, cord, glass or other foreign objects that could
get caught in the cutting bladesέ
ά Electrical shockμ Be aware of all electrical lines in the vicinityέ Check the entire
work area for the presence of power lines and electrical fences before starting to
workέ

POINTS IN OPERATION AND HOW TO STOP

τbserve the applicable accident prevention regulations!
STARTING
εove at least γ m away from the place of refuellingέ Put the pole hedge trimmer on
a clean piece of ground taking care that the cutting blades do not come into contact
with the ground or any other objectsέ
A: Cold start
1) Set this machine on a lat spaceέ
β) Set the Iάτ switch (1) to τPERATIτσέ
γ) Primer pump
Continue to push the primer pump until the fuel comes into the primer pump. (In
general, fuel comes into the primer pump by ι to 1ί pushesέ) If the primer pump
is pushed excessively, an excess of gasoline returns to the fuel tankέ
(1)
Throttle lever
Carburetor
13
τPERATIτσ
δockάoff lever
STτP
High
speed
Low speed
Primer pump