Fuel/Refuelling; Before Start Of Operation - Makita EN5950SH Originalbetriebsanleitung

FUEL/REFUELLING

BEFORE START OF OPERATION

Inspection and reill of engine oil
ά Perform the following procedure, with the engine cooled downέ
ά Set the engine level, remove oil cap (Figέ 1), and check to see whether or not there is oil in the range between the upper limit and lower limit
marks of the oil pipe (Figέ β)έ
ά Top up with oil to upper limit mark if oil is insuficient (oil level is close to lower limit mark) (Figέ γ)έ
ά The area surrounding the external marks is transparent, so the amount of oil inside can be checked without having to remove the oil capέ
However, if oil pipe becomes extremely dirty, visibility may be lost, and oil level will have to be checked against stepped section on inside of
oil pipe.
ά For reference, the oil reill time is about 1ί h (every 1ί refuelling)έ
If the oil changes in color or mixes with dirt, replace it with new oneέ (For the interval and method of replacement, refer to P1λ)
Recommended oil: SAE 1ίWάγί oil of API Classiication, Class SF or higher (4άstroke engine for automobile)
Oil volume: Approx. 0.08 L
στTEμ If the engine is not kept upright, oil may go into around the engine, and may be reilled excessivelyέ
If the oil is illed above the limit, the oil may be contaminated or may catch ire with white smokeέ
Point 1 in Replacement of oil: "Oil cap"
ά Remove dust or dirt near the oil reill port, and detach the oil capέ
ά Keep the detached oil cap free of sand or dustέ τtherwise, any sand or dust adhering to the oil cap may cause irregular oil circulation or
wear on the engine parts, which will result in troublesέ
Fig. 1
(1) Keep the engine level, and detach the oil capέ
(β) Fill with oil to upper limit markέ (see Figέ γ)
Use oil bottle when illingέ
(γ) Securely tighten the oil capέ Insuficient tightening may cause oil leakageέ
τil cap
Internal stepped
section (upper limit)
Internal stepped
section (lower limit)
τil pipe
Fig. 2 Oil pipe
External mark
(upper limit)
External mark
(lower limit)
Top up with oil
until oil level
reaches internal
stepped section
(upper limit)έ
Fig. 3
11
The area between the
external upper and lower
limits is transparent, so
oil level can be checked
extternally against these
marksέ