Cleaning The Tool - Makita UR201C Betriebsanleitung

Cleaning the tool

Clean the tool by wiping off dust, dirt, or cut off grass
with a dry cloth or one dipped in soapy water and wrung
out. To avoid overheating of the tool, be sure to remove
the cut off grass or debris adhered to the vent of the
tool.
Replacing the nylon cord
WARNING:
Use only the nylon cord with
diameter specified in this instruction manual.
Never use heavier line, metal wire, rope or the
like. Failure to do so may cause damage to the tool
and result in serious personal injury.
WARNING:
Always remove the nylon cutting
head from the tool when replacing the nylon cord.
WARNING:
Make sure that the cover of the
nylon cutting head is secured to the housing
properly as described in this instruction manual.
Failure to properly secure the cover may cause the
nylon cutting head to fly apart resulting in serious
personal injury.
Replace the nylon cord if it is not fed any more. The
method of replacing the nylon cord varies depending on
the type of the nylon cutting head.
95-M10L
► Fig.56
96-M10L
► Fig.57
B&F ECO 4L
► Fig.58
UN-74L, UN-72L
► Fig.59
Manual feed type
When the nylon cord gets short, pull it out from the
eyelet and feed it from the another eyelet.
► Fig.60
Replacing the plastic blade
Replace the plastic blade if it is worn out or broken.
► Fig.61
When installing the plastic blade, align the direction of
the arrow on the blade with that of the protector.
► Fig.62: 1. Arrow on the protector 2. Arrow on the
blade
29 ENGLISH