Specifications - Beurer BM 70 Gebrauchsanweisung

• the cuff tube is not properly inserted (
play),
• inflation takes longer than 15 seconds (
play),
• the inflation pressure is higher than 300 mmHg (
in the display),
• an error occurs when storing the measured values (
pears in the display),
• exceeding measurement range (
In the about cases, you must repeat the measurement. Make
sure that the cuff tube is properly inserted and that you do not
move or talk. Put the batteries back in if necessary, or else re-
place them.

9. Specifications

Model no. BM 70
Measurement Oscillometric, non-invasive blood
method pressure measurement on the upper
arm
Measurement range Cuff pressure 0 – 300 mmHg,
systolic 30 – 260 mmHg,
diastolic 30 – 260 mmHg,
Pulse 40 –199 beats/minute
Display accuracy Systolic ± 3 mmHg,
diastolic ± 3 mmHg,
pulse ± 5 % of the value shown
Measurement inac- Max. permissible standard deviation
curacy according to clinical testing:
systolic 8 mmHg /diastolic 8 mmHg
appears in the dis-
appears in the dis-
appears
ap-
appears in the display).
Memory
Dimensions
Weight
Cuff size
Permissible operating
conditions
Permissible storage
conditions
Power supply
Battery life
Accessories
Classification
These specification are subject to change without notice for
purpose of improvement.
23
2 x 60 memory spaces
L 156 mm x W 117 mm x H 80 mm
Approx. 535 g (without batteries)
24 to 36 cm
+10 °C to +40 °C, 40 – 85 % relative air
humidity (non-condensing)
-10 °C to +60 °C, 10 – 90 % relative
air humidity, 800 – 1050 hPa ambient
pressure
4 x 1,5 V AA batteries
For approx. 300 measurements,
depending on the blood pressure level
and/or pump pressure
Instruction for use, 4 x 1.5 V AA batter-
ies, storage pouch
Internal supply, IPX0, no AP or APG,
continuous operation, type BF applied
part