Parking The Machine; Maintenance And Repairs - Ammann AVH 7010 Betriebsanleitung

Always keep a safe distance away from the edges and banks of
ditches and refrain from any actions which could cause the
machine to topple over!
Always control the machine, so that hand injuries through hard
objects are avoided!
Always ascend slopes carefully in a direct path.
Reverse up steep slopes to prevent the machine from toppling
over on to the machine operator.
If faults on the safety devices or other faults detrimental to the
safe operation of the machine are noticed, operation of the
machine must be stopped immediately and the faults remedied.
When undertaking compaction work in the vicinity of buildings or
above pipelines and similar, check the effect of the vibrations on
the buildings and pipes and stop compaction work if necessary.

Parking the machine

Park the machine on a firm and level surface.
Shutdown the drive and secure it to prevent accidental move-
ment and unauthorised use. If available, close the fuel valve. Do
not place or store equipment with integrated moving gear on the
chassis. The moving device is intended only for transportation
purposes.
Filling petrol
Only fill petrol by switched-off motor.
No open fire, do not smoke.
Do not spill any fuel, collect discharging fuel in a suitable contai-
ner, prevent fuel from seeking into the soil.
Ensure that the filler cap is tight.
Leaky fuel tanks constitute an explosion hazard and must there-
fore be replaced immediately.

Maintenance and repairs

Observe the maintenance, inspection and adjustments and
intervals specified in the operating instructions, as well as the
information for part replacement.
Maintenance work must be undertaken only by qualified and
authorised persons.
Maintenance and repairs only by switched-off drive.
Only carry out maintenance and repairs when the machine is
parked on a firm and even surface and is secured to prevent it
from rolling.
When changing larger assemblies and individual components,
only use suitable and perfectly functioning hoistings and lifting
gears with suitable loading capacity. Attach and secure parts on
hoisting carefully!
Spare parts must comply with the technical requirements of the
manufacturer. Therefore only use original spare parts.
Hydraulic lines must previously be rendered pressureless,
before working on them. Hydraulic oil discharging under pres-
sure can cause serious injuries.
Work on hydraulic devices must be undertaken only by persons
with a special knowledge of hydraulics and the necessary ex-
perience!
Do not adjust pressure relief valves.
Drain hydraulic oil at operating temperature—caution risk of
scalding!
Collect discharging hydraulic oil and dispose of the same in an
environmentally-friendly manner.
Do not start the motor when hydraulic oil has been drained off.
After completing all work (by pressureless system), inspect all
connections and bolted connections for leaks.
Inspect all hoses and bolted connections for leaks at regular
intervals and externally visible damage! Rectify any damage
immediately.
Replace externally damaged hydraulic hoselines at regular
intervals (depending on time used), even when no safety-rele-
vant faults are visible.
Before working on the electrical system of the machine, discon-
nect the battery and insulate by covering or remove.
Inspect the electrical equipment of the machine at regular
intervals. Faults such as loose connections, worn or scorched
cables must be immediately eliminated.
During transport, secure the battery to prevent it from tilting,
short-circuit, slipping and damage.
Dispose of used batteries in a proper manner.
Do not place any tools on the battery.
Handling acid-batteries
Transport filled batteries upright to prevent acid spillage.
Keep away from sparks, open fire and other sources of ignition.
Avoid contact of acid with skin and clothing. In case of contact,
wash off acid immediately with clear water and go to medical
institution.
Properly refit and inspect all protective devices after main-
tenance and repairs.
Testing
Road rollers, trench rollers and vibrating plates must be tested
for safety by an expert depending on the particular application
and operating conditions as required, however at least once a
year.
25
1. Safety regulations