Motor Operation; Starting The Motor; Switching-Off The Motor - Ammann AVH 7010 Betriebsanleitung

3. Operation

3.5 Motor operation

The load indicator light (2) monitors the functioning of
the alternator. It illuminates when the motor stopped in
the ignition on (position «I») and must go out when
Important
motor runs.
If the starter key is not returned to «0», the signalling
device (3) will sound; there is a risk of the battery being
totally drained.

3.5.1 Starting the motor

3
B6299203.cdr
•
Set the motor speed lever to full load.
•
Turn ignition key (1), via position «I», to position «II».
•
If the motor starts, release the ignition key (1) and set the
motor speed lever to idle.
•
Allow the motor to run for 2-3 minutes in order to warm up.
Only operate the starter with a stationary motor.
Do not operate the starter for more than 20-30
Attention seconds.
Immediately release the ignition key when the
motor runs.
Wait for 30 seconds before trying again.
Never turn the key to the «0» position when the
motor is running. The regulator can be destroyed
and the battery will not charge !
3.5.2 Hand start
0
I
II
2 1
4
B6299212.cdr
Machines with electrical starter: Never hand start
with a disconnected battery, this leads to
immediate destruction of the regulator.
Attention
•
Set the motor speed control lever to full load.
•
Machines with electrical start :
Turn ignition key via position I.
•
Move the decompressor (4) lever until it stops in start position.
•
Insert the starting crank (5) and turn it with increasing speed.
B6299211.cdr
•
After starting of the motor, release ignition key.
•
Set the speed lever to idle.
•
Allow the motor to run for 2-3 minutes in order to warm up.
•
By misfire ignition return the decompressor lever to its initial
position and repeat steps 1-5.

3.5.3 Switching-off the motor

Do not switch-off the motor by full load and don' t
use the decompressor lever.
Attention
•
Allow the motor to run a short while on idling.
•
Set the speed lever to stop.
Additionally by electrostart:
•
Turn the ignition key to «0» position. (The indicator lamps
should go out.)
•
Remove the key.
At the end of a working day or a break protect the
key from unauthorised access.
Danger
30
5