Connection - Sygonix 1420408 Bedienungsanleitung

7. Connection

The surveillance camera has a connection cable with two plugs at the end.
The video signal is available via the BNC connector, e.g. to record it on a DVR (digital video
recorder). Use a matching adapter if you cannot use a BNC video cable.
The camera is connected to the external voltage supply via the round socket (direct voltage,
12 V/DC). A matching round plug is required for connection, outer diameter 5.5 mm, inner dia-
meter 2.1 mm. The outer contact of the round plug must conduct minus/-, the inner contact
plus/+.
Incorrect connection or wrong voltages will damage the camera; loss of warranty/
guarantee!
If the camera is installed and operated outdoors, the two plug connectors must only
be placed in a location protected from moisture. Observe chapter 6. If this is not ob-
served, there will be corrosion of the plug connectors!
Configure your DVR and the connected screen so that the picture from the surveillance camera
is displayed.
Important!
At commissioning, you need to first select the desired operating mode at the surveil-
lance camera, see chapter 8.
Otherwise, no picture will be shown or you will only see interferences.
After selecting the operating mode and seeing the proper display on your screen, you can align
the surveillance camera correctly so that the desired picture section can be monitored and re-
corded on your DVR.
The IR LEDs of the surveillance camera are switched on automatically in the dark. The IR light
is, however, not visible to the human eye. Observe that the image is displayed in black and white
instead of colour on a collected screen at night.
26