Installation - Sygonix 1420408 Bedienungsanleitung

6. Installation

• The surveillance camera has a pre-installed wall holder. It can be attached in a suitable loca-
tion with four screws. Use suitable screws and dowels for the surface.
You must drill a sufficiently sized hole as well to pass through the connection cable for invisible
and sabotage-proof placement.
When drilling or tightening screws, ensure that no wires or lines are damaged.
Select the assembly site so that it is protected from manipulation attempts at the sur-
veillance camera. The surveillance camera therefore should be installed at a minimum
height of 2.5 m.
• Either guide the connection cable under the wall holder on the side or push it through a pre-
sent hole in the wall where you want to screw on the wall holder.
Protect the plugs from dust and dirt, e.g. with a small plastic bag.
If the connection cable is too short (depending on the wall thickness or mounting posi-
tion), you need to use a suitable connection box. This connection box must be suitable
for assembly in the outdoor area depending on assembly site of the camera.
The cable connection for the video output or the power supply can then be placed in
the connection box; this also applies to the housing with the control lever in the surveil-
lance camera cable.
Place the cables so that they are protected from manipulation, e.g. in a cable duct or
similar.
25