Connection - Sygonix 1423058 Bedienungsanleitung

7. Connection

The surveillance camera has a connection cable with two plugs at the end.
The video signal is available via the BNC connector, e.g. to record it on a DVR (digital video recorder). Use
a matching adapter if you cannot use a BNC video cable.
The camera is connected to the external voltage supply via the round socket (direct voltage,
12 V/DC). A matching round plug is required for connection, outer diameter 5.5 mm, inner dia-meter 2.1 mm.
The outer contact of the round plug must conduct minus/-, the inner contact plus/+.
Incorrect connection or wrong voltages will damage the camera; loss of warranty/guarantee!
If the camera is installed and operated outdoors, the two plug connectors must only be placed
in a location protected from moisture. Observe chapter 6. If this is not observed, there will be
corrosion of the plug connectors!
Configure your DVR and the connected screen so that the picture from the surveillance camera is displayed.
Important!
At commissioning, you need to first select the desired operating mode at the surveillance cam-
era, see chapter 8.
Otherwise, no picture will be shown or you will only see interferences.
After selecting the operating mode and seeing the proper display on your screen, you can align the surveil-
lance camera correctly so that the desired picture section can be monitored and recorded on your DVR.
The IR-LED of the surveillance camera is activated automatically at darkness. The IR light is, however, not
visible to the human eye. Observe that the image is displayed in black and white instead of colour on a
collected screen at night.
30