Troubleshooting - VOLTCRAFT VBM-80 Bedienungsanleitung

13. TROuBLEShOOTING

With this measuring device, you have purchased a product built to the latest state of the art and operationally safe.
Nevertheless, problems or errors may occur.
For this reason, the following is a description of how you can easily remove possible malfunctions yourself:
Always observe the safety information!
Error
The meter cannot be
switched on.
No correct measured value
is displayed.
The meter cannot be
operated.
Repairs other than those described above must only be carried out by an authorised specialist.
If you have any questions about handling the meter, our technical support is available.
Possible cause
Is the battery dead?
Wrong measurement?
Is the sensor flat on the surface?
The hold function is activated
(display "HOLD").
Undefined system condition.
Remedy
Check the battery condition.
Disconnect and reconnect the battery
(perform reset).
Check the flat position of the sensor on the
measuring surface.
If required, use the enclosed adhesive
magnet.
Deactivate the hold function with the button
"HOLD".
Disconnect and reconnect the battery
(perform reset).
37