Switching On And Off; G) Menu Pre-Setting - VOLTCRAFT VBM-80 Bedienungsanleitung

f) Switching On and Off
Keep the button "POWER" (2) pushed for approx. 2 s for activation. After a brief initiation phase (display and system
test), the meter is ready for use.
Keep the button "POWER" (2) pushed for approx. 2 s for deactivation. After releasing the button "POWER", the
display "OFF" appears and the meter switches off.

g) Menu Pre-Setting

The button "MENU" can be used to pre-set some parameters such as interface, automatic deactivation and data log-
ger interval. This menu can also be used to reset the device to the factory settings and delete the data storage.
To call the menu, push the button "MENU".
1. USb: The display shows "Usb" and the figure "0" flashes. Use the two arrows buttons to change the value.
values: 0 = Interface deactivated, I = Interface active. Push the button "ENTER" to confirm the input
and switch on to the next menu item.
2. APO (Automatic deactivation): The display shows "APO" and the figure "I" flashes. Use the two arrows
buttons to change the value. values: 0 = APO deactivated, I = APO active.
when the uSB interface is active, the APO function cannot be activated!
Push the button "ENTER" to confirm the input and switch on tot eh next menu item.
3. DATA rEC: The display shows "DATA rEC" and the figure "060" flashes. Use the two arrow buttons to change
the value from 0.5 to 255. The values correspond to the interval time in seconds. Every time you
push the arrow buttons, the next charging value is selected. Longer pushing permits fast forwarding
or reversing. Push the button "ENTER" to confirm the input and switch on to the next menu item.
4. dEF The display shows "dEF" and a question mark flashes. This menu item resets the meter to pre-set
factory parameters. At the same time, all memory slots are deleted. Use the buttons "MENU" or
"ENTER" to select the desired decision:
Button "MENU" = all set parameters and the data memory are retained and the menu is ended,
Button "ENTER" = the meter is reset to factory settings and all data memories are deleted. The menu
Pre-set factory parameters
USB "0" = Off
APO "I" = On
DATA rEC "060" = interval 60 seconds
28
is terminated.