Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Special maintenance
Removing the
oven door
Periodically, it is necessary to maintain or replace
some parts that are subject to wear and tear.
Specific instructions are given below for each type
of maintenance.
Before carrying out maintenance, switch off the
power supply to the appliance and close the
gas tap.
The oven door can be completely removed to
enable more thorough cleaning. Though this oper-
ation is possible, it should not be performed by
everyone, as it requires the strength to hold up the
door and a minimum of expertise to re-fit it. If you
are not sure of being able to do this, we recom-
mend that you clean the door without taking it off
or, in special cases, that you contact the nearest
authorised service centre.
To remove the door, proceed as follows:
• Open the oven door and release the safety
catches of the hinges by turning the respective
pins A (one for each hinge) backward.
• Partially close the door until there is no more
load tension on the springs (the door will form an
angle of about 30°).
• Using both hands, accompany the movement of
the door towards closure and simultaneously lift
it upward.
• Turn the lower part of the door towards the out-
side to free the hinges B from their seats.
If you need to remove any dry residues or dust
deposited on the inner part of the windows, turn
the door upside down as shown in the figure, slide
a soft bottle brush into the spaces between the
glass plates and brush gently.
87
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
