Electric Connection - NEFF F 3430 Serie Gebrauchsanleitung

Electric connection

• Remove the packaging and the protection film
• Degrease the part of the cooker to be adjoined
to the adhesive tape
• Remove the protection film from the adhesive
tape
• Position the backsplash on the hob
• Screw the fixing plates to the cooker (A)
• Screw the fixing plates to the backsplash (B)
Make sure that the voltage and the size of the
mains corresponds to the specifications shown on
the plate located on the back of the appliance.
The plate must never be removed.
The plug at the end of the power supply cable and
the wall socket must be the same type and must
comply with current electric standards. Check that
the mains is adequately earthed. Once the appli-
ance has been installed make sure that the plug is
accessible to allow the periodical check-up.
The power supply cable should conform to coun-
try-specific regulations.
Prepare an omni-polar cutoff device on the power
supply line of the appliance with a contact opening
distance equal to or more than 3 mm, located in a
convenient position near the appliance.
Do not use reducers, adapters or shunts.
Before making the electric connection, make sure
of the efficiency of the earthing.
Make sure that the relief valve and the home wiring
system are able to withstand the appliance load.
The yellow/green earth cable must not be sub-
ject to cutoffs.
The electric cable must not come into contact with
parts whose temperature is more than 50 K higher
than room temperature.
The cooker should be installed in accordance with
the latest edition of the IEE regulations.
57