Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Special maintenance
Removing the oven
door
Parts that are subject to wear and tear have to be
maintained or replaced on a regular basis. Precise
instructions relating to certain maintenance tasks are
given below.
Before cleaning or carrying out maintenance,
switch off the power supply to the appliance and
close the gas tap.
The door can be completely removed to enable more
thorough cleaning of the oven interior. Although this
operation quite simple, it should not be performed by
everyone, as it requires the strength to hold up the
door and a minimum of expertise to re-fit it. If you
are not sure of being able to do this, we recommend
that you clean the door without taking it off or, in
special cases, that you contact the nearest autho-
rised service centre.
To remove the door, proceed as follows:
• Open the oven door and release the safety catch-
es of the hinges by turning the pins A (one for
each hinge) to the rear.
• Partially close the door until there is no more ten-
sion on the springs (the door will form an angle of
about 30°).
• Using both hands, accompany the movement of
the door towards closure and simultaneously lift it
upward.
• Turn the lower part of the door towards the out-
side to free the hinges B from their seats.
If you need to remove any dry residues or dust
deposited on the inside of the windows, turn the door
upside down as shown in the figure, slide a soft bot-
tle brush into the space between the panes of glass
and brush gently.
97
Werbung
Kapitel
Inhaltsverzeichnis
