Specific Safety Instructions - Dehn PHE III Gebrauchsanleitung

1. Specific safety instructions
Only electrically skilled or instructed persons in accordance with EN 50110-1: ... (DIN VDE
0105-100: ...) are allowed to use the PHE III... voltage detector – life hazard!
Only use the PHE III... voltage detector if fire and explosion protection measures were
taken (see B.2 and B.3 of EN 50110-1: ... (DIN VDE 0105-100: ...)).
This voltage detector PHE III... is only suitable at certain conditions (e.g. minimum distances
between phase to phase ) in factory assembled, type-tested switchgear. The user of the vol-
tage detector or the operator of the switchgear installation must contact the manufacturer
of the factory assembled switchgear installation to find out whether and where the voltage
detector may be used.
Check that the PHE III... voltage detector is in good order and condition before it is used.
If there is damage or any other defect, the PHE III... voltage detector must not be used.
Only use the PHE III... voltage detector under the requirements and conditions referred
to in these instructions for use.
If only one of the safety instructions is not strictly followed or disregarded, life and health
of the user and system availability will be threatened.
Tampering with or modification of the PHE III... voltage detector or the installation of compo-
nents from other manufacturers or of other types will threaten occupational safety, are
impermissible and will void warranty.
Page 3
1598_0314_ Mat No. 69682