Assembly Of The Attachment Pieces - Kessel InnoCleanPLUS Anleitung

4.8 Laying the connecting lines to the control unit
(ventilation hose and control line)
The control line and the ventilation hose must be laid in the
cable conduit between valve block and control unit (seePro-
cedure)
Procedure:
- Open the locking bracket on the valve block inside the tank
- Remove the valve block from the adapter plate
- Pull the grey ventilation hose and control line through the
cable conduit
- Connect the ventilation hose on the valve block using a
quick-action coupling (see 4.11 Point 5)
- Insert valve block on adapter plate
Adapter plate
Recess for
attaching the
control line
Control line
Air hoses to the compressed air syphons

4.9 Assembly of the attachment pieces

4. Installation and assembly
Air hose to the compressor
Quick-action coupling
Valve block
Locking bracket
Min. 100 mm
109
- Caution: The control line must be placed in the recess
(see figure) in order to ensure a correct latch with the ad-
apter plate.
- Check valve block for correct seat and close the locking
lever
Air connection manifold
Wastewater loading
system
Sludge transfer system
First, place the gasket (see drawing 4.9) provided into the
opening in the dome.
Grease the bottom part of the telescopic KESSEL attach-
ment piece with lubricant and place into the tank opening,
bring into the desired position and fasten by means of a
clamping ring (optional accessory). Alternatively, it is also
possible to apply lubricant to the sealing ring. With the aid of
the existing clamping ring it is now possible to fasten the
attachment piece in the desired position (alignment with the
top ground surface). The fine adjustment to the final height
is then effected with the adjusting screws. A ground slope
can be compensated for with the continuously height-adju-
stable and up to 5° inclinable attachment piece. The disposal
stickers included in the supply must be attached to the cle-
aned and dry surface on the attachment piece (see illustra-
tion).
Important: The green disposal sticker must be placed on
the inlet side and the red one on the drain side!
The attachment piece must afterwards be sufficiently back-
filled and compacted.
Air hose with compressor
Clear water removal system
Aeration tube