Hirschmann Power MICE Anwenderhandbuch Seite 100

Multicast-Routing
IGMP global einschalten am Beispiel Router A
ip igmp
Multicast global einschalten am Beispiel Router A
ip pimdm
ip multicast
exit
Prüfen der Multicast-Routing-Einstellungen
#show ip pimdm
Admin Mode..................................... Enable
PIM-DM INTERFACE STATUS
Interface Interface Mode
--------- --------------- ---------------
1/3 Enable
2/1 Enable
2/2 Enable
#show ip mcast
Admin Mode..................................... Enable
Protocol State................................. Operational
Table Max Size ................................ 256
Number Of Packets For Which Source Not Found .. 0
Number Of Packets For Which Group Not Found ... 0
Protocol....................................... PIMDM
Entry Count ................................... 0
Highest Entry Count ........................... 0
#show ip mcast mroute summary
Source IP
--------------- --------------- -------- --------- ---------------
10.0.1.159
239.192.1.1
100
IGMP am Port einschalten.
Im Konfigurationsmodus Multicast-Routing-Pro-
tokoll auswählen.
Multicast-Vermittlung global einschalten.
Wechsel in den Priviledged-EXEC-Modus.
Protocol State
Operational
Operational
Operational
Multicast Route Table Summary
Group IP
239.192.1.1 PIMDM
PIMDM 1/3
8.5 Multicast-Konfiguration
(siehe Abb.
(siehe Abb.
Incoming
Protocol Interface Interface List
1/3 2/110.0.1.159
2/2
31):
31):
Outgoing
Routing L3P
Release 3.1 08/07