Removing The Unit - Clatronic AR 759 Bedienungsanleitung

Removing the unit

Trim Plate Installation:
Push the trim plate against the chassis until it is fitted.
You must do this before you install the front panel, otherwise it can't be attached.
DIN REAR-MOUNT (METHOD B)
Installation using the screw holes on the sides of the unit.
Fastening the unit to the factory radio mounting bracket.
Due to the different vehicle types and/or vehicle manufactures, a correct configuration of the ISO
plug is not ensured; even if the ISO plug connections fir mechanically one on the other.
Therefore at some reasons it could be necessery to change and/or to use motorcar-specific adapters.
During correct connection the radio can be switches on and/or off over the ignition. With possible loss of the
stored transmitters the radio does not receive "constant current connection (B+)" that is necessary for trans-
mitter storage.
CAUTION: During a connection at „constant current connection (B+)" without ignition, for all that the
radio is switched off, an unnecessary load of the car batterie is possible. In the worst case it can cause the
unloading of the car batterie.
With Bluetooth radios it is absolutely neseccary to mind a correct connection over the ignition. Oth-
erwise there is no correct seperation of radio link between radio and mobile phone.
a. Frame
b. Insert fingers into the groove in the front of frame
and pull out to remove the frame. (When re-
attaching the frame, point the side with a groove
down wards and attach it.)
c. Insert the levers supplied with the unit into the
grooves at both sides of the unit as shown in fig-
ure until they click. Pulling the levers makes it
possible to remove the unit from the dashboard.
1. Select a position where the screw holes of the
bracket and the screw ligned (are fitted) and
tighten the screws at 2 places on each side.
2. Screw
3. Factory radio mounting bracket.
4. Dashboard or Console
5. Hook (Remove this part)
Note: the mounting box, outer trim ring, and half-
sleeve are not used for method B installation.
43