Metz Mecablitz 64 AF-1 digital - Canon Bedienungsanleitung Seite 180

transmits the data related to the lens focal
length. After the flash unit has been switched
on, „Zoom" and the current zoom position of
the reflector are shown in the display.
Automatic adjustment occurs for lens focal
lengths from 24 mm.
The automatic adjustment will not be activat-
ed if the reflector is swivelled, if the wide-
angle diffuser
Mecabounce (accessory) is mounted.
If so desired, the position of the reflector can
be manually adjusted in order to achieve par-
ticular lighting effects (such as spot effect
etc.).
Manual zoom mode
The zoom position of the reflector must be
adjusted manually to the lens focal length
when used with a camera that doesnít trans-
mit the data related to the lens focal length.
k
+
In this case auto-zoom mode is not possible!
After switching on the flash unit, „Zoom"
appears in the display and the current zoom
position of the reflector appears.
180
is pulled out, or a
Setting procedure
• Press the
for the selection menu to appear.
• Press the
PARAMETER
touch display.
PARAMETER O
• Press the
P/EV
touch display and select
ZOOM
• Press the
F
touch display.
p
q
• Press the
touch display and select the desired zoom
O
value.
ZOOM
• Press the sensor button on the touch
70
display for the desired zoom value
85
The setting will take effect immediately.
105
The following zoom positions are possible for
the reflector: 24 - 28 - 35 - 50 - 70 - 85 - 105-
p
q
135-180-200 mm (35 mm format).
Tip:
If you do not necessarily need the full guide
number and maximum flash range of the
flash unit, you can leave the zoom reflector at
the position for the shortest focal length of
the zoom lens.
This will provide full light coverage of the pic-
ture and eliminate the need to continually
adjust it to the focal length of the lens.
D
button as often as it takes
PARAMETER
sensor button on the
sensor buttons on the
ZOOM
.
ZOOM
sensor button on the
sensor buttons on the