Manual Flash Exposure Correction - Metz Mecablitz 64 AF-1 digital - Canon Bedienungsanleitung

Setting the flash frequency (f(Hz))
STROBO
• Press the sensor button on the touch
M-
2,2m
m
35
Zoom
m
4 10
N f(Hz)
P
1/16
• Press the
f (Hz) O
7
8
9
p
q
+
The maximum possible frequency of flashes
(f) depends on the set partial light output
(P).
• Press the sensor button on the touch
STROBO
k
M-
2,2m
m
35
Zoom
m
4 8
N f(Hz)
The valid distance to the set parameters is
P
1/16
shown on the display. The distance value dis-
played can be adjusted to the distance from
the subject by changing the f-stop or the par-
tial light output.
The aperture and ISO values are not shown
on the display in Strobe flash mode!
+
The secondary reflector is not supported in
the Stroboscopic flash mode.
178
display for the flash frequency
sensor buttons on the
touch display and select the desired fre-
quency of flashes.
display for the desired frequency of flashes
8
in the example .
The setting will take effect immediately.
f (Hz)
.
+
8 Manual flash exposure
correction
The auto flash exposure mode of most came-
ras is adjusted to a reflection factor of 25%
(the average reflection factor of flash sub-
jects).
A dark background that absorbs much of the
light or a highly reflective bright background
(backlit shots, for example) may result in,
respectively, underexposure or overexposure
of the subject.
To offset these effects, the flash exposure
can be adjusted manually for the shot with a
correction value. The extent of the correction
depends on the contrast between the subject
and background!
In TTL flash modes, manual flash exposure
correction factors of from -3 EV (f-stops) to +3
EV (f-stops) can be adjusted on the flash unit
in one-third increments.
Tip:
Dark subject against light background: posi-
tive correction factor.
Light subject against dark background:
negative correction factor.
Exposure correction by means of alteration of
the lens aperture setting is impossible, since
the camera's automatic exposure program
regards the altered aperture setting as the
normal working aperture setting.
When setting the correction factor, the
distance shown in the display can change