+
The maximum possible frequency of flashes
(f) depends on the set partial light output
(P).
Setting the mode of operation
• Switch on the flash unit with the
button.
The start screen appears. Thereafter, the
flash unit always switches on with the
ETTL
mode of operation that was used last .
• Press the sensor button of the displayed
0.6- 7.2 m
mode of operation on the touch display as
M-
many times as it takes for the display for
5,6
m
35
Zoom
F
m
selecting the mode of operation to appear.
EV
O
MODE
M
• Press the
STROBO
touch display and select
REMOTE MASTER
• Press the
p
q
touch display.
STROBO
• Set a suitable mode of operation on the
M-
3.1m
camera, e.g.
m
35
Zoom
m
• Tap the shutter release to transfer data bet-
5
5
N
f(Hz)
ween the flash unit and the camera.
P
1/8
sensor buttons on the
STROBO
.
STROBO
sensor button on the
M
.
Setting number of flashes (N)
STROBO
• Press the sensor button for the number of
flashes
M-
2,2m
m
35
Zoom
m
5
10
N
f(Hz)
P
1/16
O
N
• Press the
3
touch display and select the desired num-
4
ber of flashes.
5
p
q
+
The maximum possible number of flashes
(N) depends on the set partial light output
(P).
• Press the sensor button on the touch
display for the desired number of flashes
(in the example
The setting will take effect immediately.
N
on the touch display.
sensor buttons on the
4
.
177
k