Zoom Mode - Metz Mecablitz 64 AF-1 digital -Pentax Bedienungsanleitung

from unintentional discharging. The active
automatic unit switch-off is shown in the
INFO display.
The flash ready indicator
tors on the LC display disappear.
En mode veille, la touche
rouge.
The most recently used operating setting is
retained after automatic shutdown and is
immediately restored when the camera is
switched on.
The flash unit can be turned on again by
pressing the
the shutter release (wake-up function).
+
In slave-/ servo mode, the automatic cut-off
is not activated.
The flash unit should always be turned off
using the main switch
k
to be used for an extended period!
If necessary, the Auto OFF function can be set
to occur after 1 minute of inactivity, or can be
deactivated.
The flash unit switches off completely about
1 hour after its last use.
In all operating modes, the brightness of the
screen is reduced by 50 per cent after
approx. 10 seconds to save energy. The
screen brightness is restored again whenever
a button or a symbol on the screen is pres-
sed.
170
and the indica-
D
clignote en
D
button, or by tapping on
if it is not going
Setting the automatic unit switch-off
• Switch on the flash unit with the
ton. The start screen appears. The flash
unit always switches on afterwards with the
mode of operation that was used last (e.g.
manual flash mode M).
• Press the
for the selection menu to appear.
• Press the
OPTION
touch display.
O
OPTION
• Press the

ZOOM MODE

touch display and select
STANDBY
• Press the
MOD. LIGHT
touch display.
p
q
• Tap the sensor button on the touch display
O
STANDBY
for the desired time. The setting is adopted
immediately.
OFF
En mode veille, la touche
1 min
rouge.
10 min
but-
D
button as often as it takes
OPTION
sensor button on the
sensor buttons on the
STANDBY
.
STANDBY
sensor button on the
D
clignote en