Pre-Flash Suppression Or Synchronisation Settings; Servo Mode Partial Light Output Settings - Metz Mecablitz 64 AF-1 digital -Pentax Bedienungsanleitung

10.5.2 Pre-flash suppression or
synchronisation settings
• Press the sensor button
SYNC
M-Servo
display as many times as it takes for the
display for selecting the type of synchroni-
M-
sation.
m
Zoom 35
m
• Press the sensor button on the touch
P
display:
1/1
synchronisation without pre-flash
synchronisation with pre-flash
The synchronisation of operation is adop-
O
SYNC
ted.
If the synchronisation set here does not work
properly, then proceed as described in
10.5.4.
LEARN
M-Servo
SYNC
on the touch
M-
Zoom 35
P
1/8 - 2/3
1/16
1/16 - 1/3
q
M-Servo
M-
Zoom 35
+
10.5.3 Servo mode partial light output
SYNC
settings
• Press the sensor button
output on the touch display as many times
m
as it takes for the partial light output
m
display to appear.
P
1/1
O
• Press sensor buttons
touch display and set the desired partial
light output to 1/1, 1/2, 1/8 to 1/256 .
• Press the sensor button on the touch
display for the selected partial light output
p
1/16
(e.g. 1/16).
The partial light output is adopted.
SYNC
m
m
Once the slave flash units have achieved
P
flash-readiness, the AF measurement flash
1/16
flashes.
Remote channels cannot be set in SERVO
mode.
The camera flash unit may not work in the
remote mode.
P
for partial light
on the
k
191