Flash Modes; Ttl Flash Mode - Metz Mecablitz 64 AF-1 digital -Olympus-Panasonic-Leica Bedienungsanleitung

7 Flash modes

Depending on the camera model, the follo-
wing flash modes are available:

• TTL flash mode (

• Automatic high-speed synchronisation (FP),
chap. 7.4
• Automatic flash mode (
• Manual flash mode (
• Strobe flash mode (
•
(adjustable only on camera)
•
•
The flash mode is set using the touch
display.
A data transfer between flash unit and came-
ra is necessary before setting flash modes
TTL FP
k
release.
7.1 TTL flash mode (
These flash modes offer a very simple
method of obtaining very good flash shots.
Here, the exposure is measured by a sensor
in the camera. It measures the light reflected
by the subject through the lens (TTL =
"Through The Lens").
If the shot was exposed correctly, the correct
exposure indication will illuminate for about
3 seconds (see 4.2).
158
TTL
), chap. 7.1
A
), chap. 7.5
M
), chap. 7.3
STROBO
), chap. 7.6
REMOTE MASTER
flash mode
REMOTE SLAVE
flash mode, chap. 10.2
SERVO
flash mode, chap. 10.4
M FP
and e.g. by actuating the shutter
TTL )
When taking a shot, an almost imperceptible
measurement pre-flash is triggered by the
camera prior to the actual exposure process.
Setting the mode of operation
• Switch on the flash unit with the
button.
MB 64AF-1
The start screen appears. Thereafter, the
flash unit always switches on with the
digital
mode of operation that was used last
OLY
(e.g. M flash mode).
V 1.0
• Press the displayed mode of operation on
M
the touch display as many times as it takes
for the display for selecting the mode of
9.0 m
operation to appear.
M-
5,6
m
35
Zoom F
m
P
1/1
O
MODE
• Press the
touch display and select
TTL
• Press on the selected mode of operation
A
that is highlighted in yellow. The setting is
adopted immediately.
p
q
• Set a suitable mode of operation on the
camera, e.g. P, S, A etc.
• Tap the shutter release to transfer data bet-
ween the flash unit and the camera.
sensor buttons on the
TTL
.