Flash Bracketing Series („Fb"); Auto Off For The Flash Unit - Metz MECABLITZ 50 AF-1 digital Nikon Bedienungsanleitung

9.3 Flash bracketing series („FB")
A series of flash exposures FB (flash bracketing) can be carried out in the TTL
TTL TTL TTL
flash modes ( , BL, ,
consists of three successive flash shots with different flash exposure correction
values:
• The first shot is carried out without correction value.
• The second shot is made with a minus correction.
• The third shot is made with a plus correction.
• After the third shot, the flash bracketing series is automatically deleted.
A flash bracketing series can only occur if the camera supports the set-
ting of a manual flash exposure correction on the flash unit (see ch. 8
and the camera's operating instructions)! Otherwise the shots will be
made without correction values!
Setting procedure
FB
FB
1,3
FB
1,3
FB
104
TTL
BL; see 7.1). A flash bracketing series
• Press the button combination „Select" until
„FB" flashes in the display.
• Apply the setting desired with the buttons
+ and —. The possible correction values
range from 1/3 to 3 apertures in one-third
aperture increments. The correction value
will always be shown positively.
The setting takes effect immediately.
After about 5 seconds the display stops flas-
hing and the setting is saved automatically.
For the first shot of a flash bracketing series „FB" and „A"re shown in the
display. For the second shot „FB", „B" and the minus correction values are
displayed. For the third shot „FB", „C" and the plus correction values are
displayed. After the third shot, „FB" is deleted from the display and the flash
bracketing series is deactivated.
It must be reset for another flash bracketing series!

9.4 Auto OFF for the flash unit

The auto OFF for the flash unit can be set so that it occurs after 10 minutes, 1
minute or is deactivated.
Setting procedure
• Press button combination „Select" until
the symbol flashes.
• Apply the setting desired with the buttons + and —.
– When „10min" is displayed, Auto OFF
function will be activated after 10 minu-
tes.
– When „1min" is displayed, the Auto OFF
will be activated after 1 minute.
– When „OFF" is displayed, the Auto OFF is deacti-
vated.
The setting takes effect immediately.
After about five seconds the display stops flashing and the setting is saved auto-
matically.
After activation of the auto OFF the display shows
OFF
10min
10min
OFF
10min
.