Servo Mode; Flash Bracketing Series („Fb") - Metz MECABLITZ 50 AF-1 digital Canon Bedienungsanleitung

9.2.2 SERVO mode

Servo mode is a simple slave mode with complete preflash suppression, in
which the slave flash unit always triggers a flash as soon as the camera flash
unit receives a light pulse.
Adjustment procedure for SERVO flash mode
• Set the camera to E-TTL mode.
SL SL
On
M
SERVO SERVO P 1/1
Zoom 24 mm
• Partial lighting levels can be set with the + and - buttons.
• Wait for the flash-readiness of all connected flash units. Once the slave flash
unit is ready, its AF measuring beam
Slave groups and remote channels can not be set in SERVO mode.
The flash unit may not be activated in remote mode.
• Press the "Select" button repeatedly until
SL
blinks on the display.
• Press the + button to activate remote slave
mode.
• Press the + button again and activate ser-
vo mode. In servo mode, only manual
flash mode is possible. Manual flash mode
M
is automatically activated after swit-
ching to servo mode.
will start blinking.
Turn off SERVO flash mode
• Press the button sequence repeatedly until
SERVO blinks on the display.
• Press the – button twice to turn the SERVO
mode off.
9.3 Flash bracketing series („FB")
A series of flash exposures FB (flash bracketing) can be carried out in the TTL
TTL TTL TTL
flash modes ( , E , E HSS; see 7.1). A flash bracketing series consists
of three successive flash shots with different flash exposure correction values:
• The first shot is carried out without correction value.
• The second shot is made with a minus correction.
• The third shot is made with a plus correction .
• After the third shot, the flash bracketing series is automatically deleted.
A flash bracketing series can only occur if the camera supports the set-
ting of a manual flash exposure correction on the flash unit (see ch. 8
and the camera's operating instructions)! Otherwise the shots will be
made without correction values!
SL
OFF
OFF
95