Manual Wireless Slave Mode - Metz MECABLITZ 15 MS-1 digital Bedienungsanleitung

set if a fixed channel is not used in
the remote system.
In the case of "CHANNEL ALL", all
set channels are activated.
In the remote operating modes,
groups can be set in addition to the
channels (CHANNEL) in order to con-
trol the desired slave flash unit of a
specific group.
The setting of groups (GROUP A, B,
C) is only possible in Canon, Nikon
and Olympus remote control modes.
Setting a channel (CHANNEL) and a
group (GROUP) in a camera-specific
remote system
• Keep the button "AF/SELECT"
S E L E C T
pressed on the flash unit until the
⊃
following message appears in the
S E L
display:
M O D E L L I N G
• Press the button
L I G H T
O N
O F F
unit. In the display appears::
S E L
OK
• Press the button
SYSTEM
OLY REMOTE
unit. The most recently used setting
Ch ALL Gr A
appears in the display, e.g.:
S E L
OK
76
SYSTEM
OLY REMOTE
Ch 3
S E L on the flash
S E L
on the flash
• Press the button
CHANNEL ALL
unit. In the display appears:
S E L
• Press button
CHANNEL 3
desired channel (CHANNEL ALL –
CHANNEL 1..4).
S E L
• Press button
GROUP A
remote channel is set. In the display
appears:
S E L
• Press button
GROUP A
ired group (GROUP A, GROUP B,
GROUP C).
S E L
• Press button
group is set.
Gr A
S E L
OK
• Press button
OLY Ch3 GrA
te channel and remote group are
1:1
set.
5 Manual wireless slave
mode
Even when cameras are used without
a camera-specific remote system,
wireless release of one or more slave
flash units is possible.
S E L on the flash
and select the
S E L
, the selected
and select the des-
S E L
and the desired
, the selected remo-
OK