Additional Safety Instructions - Parkside PHS 160 D4 Originalbetriebsanleitung

GB
• Disconnect the plug from the
power source and/or the bat-
tery pack from the power tool
before making any adjust
-ments, changing accessories, or
storing power tools. Such preven-
tive safety measures reduce the risk of
starting the power tool accidentaIly.
• Store idle power tools out of the
reach of children and do not al-
low persons unfamiliar with the
power tool or these instructions
to operate the power tool. Power
tools are dangerous in the hands of
untrained users.
• Maintain power tools. Check
for misalignment or binding of
moving parts, breakage of parts
and any other condition that
may affect the power tool's op-
eration. If damaged, have the power
tool repaired before use. Many acci-
dents are caused by poorly maintained
power tools.
• Keep cutting tools sharp and
clean. Properly maintained cutting
tools with sharp cutting edges are less
Iikely to bind and are easier to control.
• Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, tak-
ing into account the working
conditions and the work to be
performed. Use of the power tool for
operations different from those intended
could result in a hazardous situation.
• Hold the device by the insulated
gripping surfaces when per-
forming work in which the cut-
ting tool may come into contact
with hidden wiring or its own
cord. Contact with a live wire can also
cause a charge in metal parts of the
device and result in an electric shock.
8
5) SERVICE
• Have your power tool serviced
by a qualified repair person us-
ing only identical replacement
parts. This will ensure that the safety
of the power tool is maintained.

Additional safety instructions

Warning! Sanding can result
in the formation of haz-
ardous dusts (e.g. arising
from materials with paints
containing lead, materials
containing asbestos, metals
or some wood types) which
can present a hazard to the
operator or persons in the
vicinity. Make sure that the
workplace is well ventilated.
Always wear safety goggles,
safety gloves and respiratory
protection.
Secure the workpiece. A work-
•
piece that is retained with clamping
appliances or a vice is held more se-
curely than with your hand.
Only use the power tool for dry
•
sanding. Do not scrape moist
materials. Penetration of water into
the power tool increases the risk of
electric shock.
Avoid overheating the sanded
•
object and the sander itself. Pos-
sible fire hazard.
The workpiece gets hot dur-
•
ing grinding. Do not touch the
machined area, allow it to cool
down. There is a risk of burning. Do
not use coolants or the like.
Always empty the dust con-
•
tainer before work breaks.