General Safety Regulations; Safety Instructions Electricity; Intended Use - Cornelius LOOP Serie Gebrauchsanweisung


2. Safety Regulations
2.1

General Safety Regulations

This unit is of leading-edge design and manufacture. If used and maintained in accordance with these operating
instructions, it will be safe to operate. Please comply with the following safety instructions to avoid hazards and
damage.

The device must be in satisfactory condition whenever operated. Any modifications which
detrimentally affect the safety of the device are therefore strictly prohibited. Please contact your service
company if you wish to obtain more information about safety.

No safety equipment (such as safety valves, overload protection devices, etc.) is to be removed,
modified or put out of commission (risk of injury or death!).

Take care that only authorized persons work on the device and that the operators are trained. Make
certain that no unauthorized persons change the settings on the device or tamper with it.

The unit is filled by the service technician with water and adjusted to temperature or ice bank mode.
The operator must not open the unit.

You are obligated to check the device on a daily basis for externally discernible damage and defects.
Immediately report modifications which affect safety and function to the service company nearest you.
Discontinue operation if necessary.

Note that only original CORNELIUS replacement parts and accessories which have been checked and
approved are to be used. IMI Cornelius Deutschland GmbH assumes no liability whatsoever for damage
resulting from the use of non-original parts and accessories or from improper handling.

This device is not determined by persons (including children) with reduced physical, sensory or mental
abilities or lack of experience and / or lack of knowledge to be used, unless they are fully supervised by
a person who is responsible for their security or received their instructions, as the device is to use.
Children should be supervised to ensure that they do not play with the device.
2.2

Safety Instructions Electricity


An electric shock may be fatal or result in serious injury. For this reason, any unauthorized tampering is
strictly prohibited. Water and electricity are a fatal mixture!

It is strictly recommended to operate the device with an electrical fault protection switch (FI) only

Always pull out the mains plug before any cleaning work on or near the device.

As delivered, it features a moulded earthed-pin plug and it must be connected to a socket outlet with an
earthed contact. If no appropriate socket outlet with an earthed contact is available, the connection must
be made by authorized persons only, with the regulations applicable at the installation site (EN
standards in Germany, for example) being observed.
2.3 Safety Instructions CO

Place the carbon dioxide cylinder in an upright position next to the workstation and secure it against
falling over.

Protect it against heat (e.g., against sunshine). Minimum distance from heater 0.5 m (TRSK).

Escaping carbon dioxide is heavier than air and may present danger of suffocation if large quantities
collect in enclosed spaces.

Use Food suitable CO
Remember that parts of the device are at operating pressure. Do not loosen or dismantle any components at
operating pressure.
3.

Intended Use

The LOOP-Range is designed for cooling and dispensing non-alcoholic drinks and their base/syrup.
Food suitable CO is used for the propellant. The cooling of other drinks or liquids is forbidden.
2
The inlet temperature of the liquid must not exceed 32°C otherwise the pressure in the refrigeration cycle will
rise above specification.
Minimum ambient temperature 10°C, maximum ambient temperature 40°C.
The energy exchange from the cooling coil to the premix drink coil takes place in a liquid bath with water.
2
only
2
23
LOOP